• Center Hung Cable Tray Support allows cable to be installed from both sides
• Eliminates costly cable pulling and field cutting of cable tray supports. Labor costs are drastically reduced
• Required hardware and threaded rod material for trapeze assemblies are reduced by 50%
• Designed for use with ½” threaded rod (order rod separately)
• Use with all aluminum and steel cable trays up to 24″ in width
• Load capacity is 700 lbs. per support. Safety factor of 3
• Eccentric loading is not to exceed a 60% vs. 40% load differential
• The maximum recommended unsupported span length is 144″/12 ft. (3.66m)
• Furnished with installation hardware
Read More
• Designed for use as a rooftop support for cable tray
• Each support has rubberized pads on the underside of each leg to minimize any chaffing of the existing rooftop
• Can be used with any of Snake Tray cable tray clamps and guides
• Ultimate Load Capacity: 1,000 lbs. (uniform load)
• Patio blocks are not included
Read More
• Provides the necessary components for a single trapeze support in one kit. These kits are available in pre-galvanized steel with zinc plated hardware
• The support bar provides convenient pre-punched slots, eliminating the need for field drilling
• The entire kit is sealed in a plastic bag and boxed with the channel, which is pre-cut to the appropriate length as shown in the chart
• Designed for use with ½” threaded rod (order rod separately)
Read More
• Bonding Jumper not required.
Read More
• Use at each expansion splice and where the cable tray is not mechanically/electrically continuous to ground
• Installation hardware included
• Bonding jumper is 16″ long
• Sold individually
Read More
• Creates a barrier at the terminal end on the cable tray run
• Furnished with installation hardware
• Sold Individually
Read More
• Horizontal Bend Barriers are flexible in order to conform to any horizontal radius
• Cut to length
• Furnished with three #10 x ½” zinc plated self-drilling screws
• Standard length is 60″ (5 ft.)
• Sold individually
Read More
